ALLIGATOR

This is Alligator with a taped design. 3 brushed coats will give a smooth, matte finish.


This is the glaze applied more thickly, which gives texture. More on the 'wave design' technique later.

                Here is Alligator heavily applied and heavily reduced with tape design.



RECIPE:
Alligator is another glaze you mix by volume not by weight. Similar to Blue Velvet.

Gerstley Borate  4 parts
Neph. Sye.   1 part
Bone Ash     2 parts
Copper Carb.   1 part

Mix with water and sieve twice. Apply 3 brushed coats for a smooth finish, more for texture. 

Fire to 1750F and reduce heavily. That means put it in the bucket, lid on and leave until cool.
Clean in soapy water with a non-abrasive scrubber.

Comments

Post a Comment

Popular posts from this blog

NAKED RAKU with and without GLAZES

Image
  This bowl is Naked Raku without the addition of other glazes. This bowl has Blue Velvet and Apple Red, with the Naked Raku. ' NAKED RAKU' is a technique that uses slip and a 'glaze' to achieve crackle effects on bisqued ware. It's called Naked because the piece is not glazed per se. Just smoked- patterned  bisque. The piece is painted with the slip (recipe to follow) then covered with a 'glaze' (recipe below). It's not rocket science once you get the hang of it so I wanted to see what else I could do.  The slip/glaze was applied to specific areas sometimes in a planned design, then 3 coats of Blue Velvet was applied to all other areas butting right up to the slip. Occasionally I applied Spectrum Apple Red to add more interest. The pieces were fired to 1700F then post-fired as usual, one quick 'burp' then lid on until cool.  Getting the slip off can be tricky but do not submerge in water no matter what you may read elsewhere. Things get gummy a
Read more

INTEGRATING DESIGNS

Image
This bowl in the  'Byzantine Crackle'  technique was cr eated like this:  On the inside of the  bisqued bowl I drew the dual leaf-frond pattern then applied wax resist carefully to articulate the design. Then 3 coats of White Crackle was applied with a wide hake brush to the entire piece. A small damp sponge cleaned off the waxed pattern if glaze stuck there. It was fired to 1750F and allowed to cool in the kiln.Then with a soft fan brush Blue Velvet was applied over the entire piece and right away you can see the crackles absorbing the glaze. This takes practice not to brush the glaze off the crackles. Be patient. Where the pattern was waxed and burned out, the bowl will have a pure Blue Velvet  glaze. Fire to 1800F and post fire. The design of the flying geese was made like this: First the geese were drawn to a scale that suited the size of the bowl in different flying configurations, then 3 coats of Mayco White glaze was carefully applied with a fine brush. The bowl was fire
Read more

THE BUTTERFLY EFFECT

Image
The pink butterfly design is a commercial glaze. I stumbled upon this effect by accident when I was using a commercial glaze for a fan design. (See previous post picture).I drew the butterflies on the interior of the bisqueware, then applied 3 coats of a pink glaze  by Mayco. I fired the piece to 1750F and let it cool in the kiln.  I applied Blue Velvet over everything and poured extra into the base of the piece for a textured effect. I noticed that the crackles in the pink glaze were absorbing the Blue Velvet along it's crackle lines! The piece was dried completely. This articulated wonderful patterns. Then the piece was fired to 1800F and post fired.  
Read more